Add: Wanda Plaza, Fuqiao Street, Rencheng District, Jining City, Shandong Province, China
+86-18206519878
   Home > News > How to Compare Cable Coil Band Positions…

How to Compare Cable Coil Band Positions Across Production Lots

How to Compare Cable Coil Band Positions Across Production Lots

A supplier can compare band positions across production lots if each sample has the same orientation and a measured clearance. Keep the approved photos as a reference. Photograph a coil from each new lot and put its lot and sample ID in the frame. The original photo alone cannot show what changed.

Give every coil a repeatable starting point

Place the same face up. Choose a feature that the operator can find again, such as the point where the lead exits the winding. If that point varies between lots, use a marked support to orient the coil and record the lead exit separately. Label each band on a copy of the reference photo. A rotated coil can make an unchanged band look misplaced.

Take three views before moving the sample

  1. Whole coil. Photograph the ring face-on, with every band, the reference mark and the sample ID visible. Use the same support for both lots.
  2. Band and protected feature. Show the nearest band edge and the connector or other area that must remain clear. Measure the gap on the physical sample in millimetres. A ruler in the photo gives scale, but camera tilt can distort the reading.
  3. Side of the bundle. Show the stack of turns and the band joint. If a connector hides the band edge, add a view from the opposite side before approving the position.

White coil beside the KPW-1216 open arch, showing the coil wall where the band passes

Keepway equipment reference. For a lot comparison, photograph your own coil in the same orientation each time.

Decide what passes and what needs another trial

Agree the minimum clearance or permitted band location with the buyer before evaluating the next lot. Record one line per band with the lot and sample ID, band ID, reference point, required clearance, measured clearance, visible marks and decision.

  • If both views use the same reference and the measurement meets the agreed limit, record the position as accepted.
  • If the band crosses a protected area, mark that sample and request a trial with the band repositioned.
  • If the reference or edge is hidden, request a new image and measurement. Keep this outcome separate from a failed trial.

Position, retention and surface marks are separate checks. Where handling matters, repeat the agreed packing or unpacking step, then inspect the lead and contact area. Use the guide to lead-end access after banding to define that check.

Request a KPW-1216 sample review

Send one labelled set per lot, the coil centre opening, the local bundle width and stack height where the band will pass, and the required number of bands. Mark the minimum clearance your next operation needs.

Request a coil sample review